Midgetec

I've still got some housekeeping to do, but here is the Duratec nestled into the Midget.  As you might have seen in some of the old posts, there was a little sheetmetal work to do, but not too bad.

I still have to clean up some wiring mods that I made after I 'finished' the wiring a few months ago, but it's in pretty decent shape.  You can see the fuel rail I fabricated to a) give it a lower profile for hood clearance and b) give me an 'in' and an 'out' for a back-pressure regulator setup.  The original Focus installation used a PWM signal to the fuel pump to regulate pressure at the rail, and therefore only had a single fuel connection.

You can also see the Megasquirt relay board mounted to the upper left of the engine.  The Megasquirt module is in the passenger footwell.

This was taken about 5 or 6 weeks ago.